Fujitsu telefon SRS-1050 Manual

PDF-manualer
131 Sidor Engelska

Fujitsu telefon SRS-1050
SRS-1050 Voice Features ( Chapter 2
Page 2-2
Switching between Handset
and Handsfree Modes
If you are using the handset
and want to use handsfree
mode
Note: These procedures assume
that the phone is set to
ringing line preference or
primary line preference.
1. Press SPEAKER and then
replace the handset in its cradle.
You now hear the other parties
on the call through the speaker.
2. If the MIC-OFF LED is red, the
microphone has been turned off.
Press MIC-OFF to turn it back
on (the LED goes dark). The
microphone now picks up your
voice.
3. You can turn off the microphone
by pressing MIC-OFF, allowing
you to hold a private
conversation with others in the
room. Pressing MIC-OFF again
turns the microphone back on.
Note: If the MIC-OFF feature is
not active on the upper right
corner multifunction button,
the microphone is always on.
If you are using handsfree
mode and want to use the
handset
Pick up the handset. Your call
continues without interruption.
The handsfree speaker and
microphone are turned off.
Placing Handset Calls
If you are not talking on
another call
1. Pick up the handset. This
should automatically give you a
dial tone, if not press an idle Call
Appearance (CA).
• If this connects you with a
ringing call, follow the
procedure described in the
next section.
• If you want to place the call
from a Call Appearance other
than the one automatically
selected, press its CA button.
2. Dial the desired number by
pressing the keys on the
numeric keypad.
3. If your call is not answered, you
can hang up as follows:
a. Replace the handset in its
cradle.
or
Relaterade manualer för Fujitsu telefon SRS-1050
F9600 F9600c
Fujitsu telefon F9600 F9600c

För telefon (96 Sidor)
280D-HS
Fujitsu telefon 280D-HS

För telefon (2 Sidor)
SRS-2100
Fujitsu telefon SRS-2100

För telefon (176 Sidor)
F9600
Fujitsu telefon F9600

För telefon (19 Sidor)
SRS-9924-ABM
Fujitsu telefon SRS-9924-ABM

För telefon (115 Sidor)